Power Panel Systems
Balance your system
Finally a Low Cost Alternative to Assembling Components in the Field
Power Panels are Trace's first packaged power system. They are less expensive than an
on-site component installation and may power application needs. To install a Power
Panel simply connect them to the battery, PV and/or AC loads, Power Panels include
inverters and are assembled by Trace with components specified by the dealer or customer.
 |
Included in all Power Panel Systems:
 | Powder-coated steel back plate, pre-wired with all NEC / UL required AC & DC over current protection and disconnects (only for indoor installation). Simply connect to the battery and AC loads and your system is operational. |
| Can be used with wind, solar, or hydro- DC charging sources |
| 60 amp AC system bypass that allows inverter servicing while keeping AC loads connected to the grid or generator |
| Flexible conduit for connection of the system to the battery enclosure |
| ETL listed components and enclosure |
| Negative/ground bonding block |
Options:
| Optional nonmetallic battery enclosure which doubles as a shipping enclosure |
| Single or dual C40 Charge controllers for solar, wind, hydro- DC charging sources |
| One or two Trace "SW" or "DR" inverters |
"SW" Series Power Panels
| Sine wave AC power inverter with high-efficiency, bi-directional operation |
| Up to 11 kW of continuous AC power |
| Up to 60 amps of AC input from a generator or utility grid |
| Three-stage, temperature-compensated battery charging (up to 300A @ 12VDC, 240A @ 24 VDC, and 150A @ 48 VDC) |
| Utility-interactive and generator-support operating modes |
| Able to regulate up to 4.8 kW of power from solar or other DC charging sources |
| Available outputs of 105, 120, 230 or 120/240 vac at 50 or 60 Hz. |
| Available for a 12, 24 or 48-volt DC system |
"DR" Series Power Panels
| Modified sine wave AC power inverter with high efficiency operation and battery charging ability |
| Up to 7.2 kW of continuous AC power (120/240 vac systems) |
| 30 amps of AC pass through power at 120 or 120/240 vac from a generator or utility grid to your loads, in addition to the charger draw |
| Three-stage, temperature-compensated battery charging - up to 240 at 12 VDC, or 140A at 24 VDC |
| Able to regulate up to 2.4 kW of power from solar or other DC charging sources |
| Available outputs of 105, 120, 230 or 120/240 vac at 50 or 60 Hz |
| Available for 12 or 24 volt DC system |
| Note: Products
are listed by UL and/or ETL to
UL Note Year 2000: Trace products do not utilize date sensitive chips. Therefore inverters and other Trace equipment are not susceptible to Year 2000 complications. |